Installing ZAGG Ultra Clear® on Google Pixel Watch

Today, we’ll show you how to install your ZAGG InvisibleShield Ultra Clear Screen Protection on your Google Pixel Watch. Inside the package, you’ll find a paper box with two separate compartments.

The larger compartment on the bottom contains installation instructions, a wet wipe, a microfiber cleaning cloth, a dust removal sticker, and a squeegee. The smaller compartment on top contains the InvisibleShield screen protector. Warranty information is printed outside the box, so let’s get started!

Installing ZAGG Ultra Clear® on Google Pixel Watch

First, lay your watch down on a flat surface you can use for installation. Then, clean your screen using a wet wipe to remove any smudges and oils from your screen. Follow up with the microfiber cloth, and finally, use the dust removal sticker to pick up any debris that may have settled back down on the screen. Now you’re ready to install your InvisibleShield!

Peel away the white protective layer using the tab labeled one. Align the InvisibleShield to the center of the watch screen and place it on the watch. Keeping the screen display on may help you align to the center flat surface of the show. Start at the top and run the squeegee down the screen.

This will activate the built-in static dust removal layer. Lift the top half of the screen protector labeled two while maintaining alignment with the bottom half. Starting just below the lifted top half, run the squeegee up to the top of the screen. This will apply the screen protector and push off the protective backing labeled one.

Starting at the midpoint again, lift the lower half of the screen protector labeled three and squeegee down to the bottom of the screen. This will apply the screen protector and push off the defensive back marked three. Push any remaining bubbles to the sides using the squeegee or your fingers.

Use your thumb to press the sides of the InvisibleShield down along the edges of the watch. Carefully remove the top protective layer. Microbubbles should disappear within 24 hours. You can also gently press out bubbles to the side of the screen with your finger or cloth. Use the microfiber cloth to wipe away any fingerprints.

Now you’re protected by the number one trusted brand in screen protection, InvisibleShield. Protect better with ZAGG.