Installing InvisibleShield GlassFusion Screen Protection

Today we will show you how to apply the InvisibleShield glass fusion.

Inside the box, you will find a product quality assurance card, a screen wipe to clean the screen, a microfiber cleaning cloth, a dust removal sticker to remove lint or dust, an installation tray, and the invisible film.

First, clean the screen with a wet wipe to remove smudges and oil. Then use a microfiber cloth to clean again. Finally, use the dust removal sticker to remove fine lint or dust.

How To Installing InvisibleShield GlassFusion Screen Protection

1. Now start preparing for the installation.
2. Place the phone on the mount, making sure the top of the phone is secured to the top of the unit.
3. Peel off the white protective layer with the tab labeled number one, and do not touch the exposed surface.
4. Place the invisible phone case on the fixture.
5. Place the cutout on each tab on the corresponding peg on the tray with the exposed adhesive side facing down towards the front of the phone screen.
6. Starting from the center of the screen, scrape and slide around to squeeze out the air bubbles.
7. Carefully peel off the top protective layer and remove the phone from the fixture.
8. Using a squeegee to move the squeegee along the sides of the InvisibleShield in a smooth motion.
9. Not back and forth, which can cause air bubbles.

During installation, for best results, use a microfiber cloth to wipe any fingerprints, dust, or debris that may have accumulated on the InvisibleShield.
Be sure to set up or reset the fingerprint scanner after installing the InvisibleShield.